| Pin Number | Wire Color | Signal Function | Notes | |------------|------------|----------------|-------| | 1 | Red | Battery+ (VCC) | Typically 24-48V | | 2 | Blue | RX (Receive data) | From display to controller | | 3 | Black | Ground (GND) | Common negative | | 4 | Green | TX (Transmit data) | From controller to display | | 5 | Yellow | Controller lock (power switch) | Some versions use for lights |

A: The controller isn’t sending speed signal. Check hall sensor wire or external speed sensor connection. Conclusion This Kt 70 Installation Manual has covered everything from pinouts and wiring to advanced torque sensor calibration. A properly installed Kt 70 transforms a generic e-bike kit into a responsive, informative riding experience.

After changing a parameter, press Power to move to the next. When finished, press and hold Power for 3 seconds to exit. The display will reboot. Chapter 7: Torque Sensor Calibration (T_Sensor Mode) If you are using a torque simulation (T_Sensor) bottom bracket (e.g., Sempu, T4, Bafang torque sensor), the Kt 70 needs calibration.

A: Only if your controller is rated for 52V. The Kt 70 will read up to 60V but may show inaccurate battery bars. Set P3=4 (auto-detect) and monitor actual voltage.